Two process control signaling schemes were to be supported — the 0 to 10 VDC analog signal, and the venerable 4-20 mA current loop.

Figure 2 This simple current source (Simple Source) circuit provides accuracy with a single resistor by floating the power supplies of the output stage. Isolated dual output DC to DC converters are ...

The circuit shown is a simple current limiter and is recommended since it offers a higher efficiency than other transistor circuits. It works to limit the current through R_sense such that the ...

A Simple Over-Voltage Protection Circuit for LED Drivers This boost circuit implements current mode control and senses the LED current via resistor R14. The output voltage is boosted to just over 30V ...

1. A simple, widely used current limiter consists of a current sensor (usually a low-value sense resistor), a control circuit, and a pass transistor.

1. Shown is an example of a simple circuit (TI reference design PMP9759) that bidirectionally drives current through a TEC; the single-chip buck-boost converter requires a minimum number of ...

Short circuit current ratings should not be overlooked during panel design. Negative impacts can occur to production, equipment and, worst case, plant personnel.

This SCR phase control works much like the common TRIAC dimmer, but has numerous advantages including increased current capability, robustness and absence of minimum voltage “snap-on.” A complementary ...